You can also reset, and program the service interval reminder. You will need the vehicle security code, which can be found on the CAR-PASS. You can also reset, and program the following immobiliser related items: This will helps you find failed components.Ī key feature with this diagnostics interface is the immobiliser learning function, and programming central locking behaviour with the remote key fob. You can get feedback on the state of any activated output. SWCAN – Single-wire, Low Speed CAN-BUS, 33.3 kbps MSCAN – Dual-wire, Medium Speed CAN-BUS, 95 kbps HSCAN – Dual-wire, High Speed CAN-BUS, 500 kbps You can also run output tests on many controllers, such as: The newest CAN based control units are extremely fast. For example, older systems, such as ISO-9141-2 protocols can be very slow, during communication, while newer Multec or Bosch units are faster, using KWP-2000 protocols. The sample rate is dependent on the communication protocol. The program is capable of showing 8 measuring block parameters simultaneously. The program shows you measuring block information on the control modules. You can then print out, save, or copy the fault codes to any other application.įrom the fault codes window, you can go directly to the measuring blocks window. Read out and clear fault codes (see below for more information)įault codes, show full complete descriptions and status information, (ie, present, not present or intermittent). It covers most Opel cars from 1996 to present with CAN-BUS based diagnostics, such as Vectra-C, Astra-H, Zafira-B.
0 kommentar(er)
